Hyundai Elantra AD Quiz
Engine Mechanical System

Oil Pressure Switch Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal and Installation

  1. Disconnect the oil pressure sensor connector (A), then remove the oil pressure sensor (B).

    Tightening torque: 9.8 ~ 11.8 N·m

  2. Install in the reverse order of removal.
  • When installing the oil pressure switch, apply sealant to the threads.
Sealant: THREEBOND 2403. Thickness: 0.2 ~ 0.4 mm (0.008 ~ 0.016 in)

Inspection

  1. Using an ohmmeter, check continuity between the terminal and the body. If there is no continuity, replace the oil pressure sensor.
  2. Check continuity between the terminal and the body while pressing the thin wire. If there is continuity even when the thin wire is pressed, replace the switch.
  3. If there is no continuity when 50 kPa (0.50 kgf/cm², 7.25 psi) is applied through the oil passage, the switch operates correctly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.