Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Rear Seat Belt Buckle Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
3steps
~18min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 3

Replacement

  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Cushion Assembly")
  2. Loosen the mounting bolt and remove the rear seat belt buckle (A). [LH]

    Tightening torque: 39.2 ~ 54 N·m

    [RH]

    Tightening torque: 39.2 ~ 54 N·m

  3. To install, reverse the removal procedure.
    • Buckles and tongues of different types cannot be latched together. Make sure the buckle and tongue are of the same type.
    • Before latching the buckle, distinguish the rear side seat buckle from the center seat buckle.
    • If foreign matter (viscous drinks, toothpicks, sand, plastic, vinyl, metal parts, etc.) becomes lodged in the buckle's internal button, it may interfere with latching and cause a malfunction.
    • After latching the buckle and tongue, check the latching force with a push-pull gauge (latching force: 3 kgf or less).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.