Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Rear Seat Belt Pretensioner Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
4steps
~24min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Replacement
  • When installing the seat belt, take care not to damage the pretensioner.
  1. Remove the parcel tray trim. (Refer to Interior Trim - "Parcel Tray Trim")
  2. Loosen the mounting bolt, then remove the lower anchor of the rear seat belt (A).

    Tightening torque: 39.2 ~ 54 N·m

  3. Loosen the pretensioner mounting bolt (A), then remove the rear seat belt (B).

    Tightening torque: 39.2 ~ 54 N·m

    [LH]
    [RH]
  4. To install, reverse the removal procedure.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.