Hyundai Elantra AD Quiz
Suspension System

TPMS Receiver Repair Procedures

In this manual: Suspension System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
10steps
~60min
3/5difficulty
Done 0 of 10

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the glove box. (Refer to Body - Glove Box Assembly Upper Cover)
  3. Remove the smart key unit. (Refer to Body - "Smart Key Unit")
  4. Disconnect the connectors from the Body Control Module (A).
  5. Remove the Body Control Module (A) after loosening the mounting nuts.

Installation

  1. Install the Body Control Module.
  2. Connect the Body Control Module.
  3. Install the glove box upper cover assembly.

Adjustment

Diagnostic Procedure Using Scan Tool

The main content of the diagnostic procedures using the scan tool is as follows:
  1. Connect the diagnostic link connector (16-pin), located in the lower cover on the driver's side, to the scan tool, then turn the scan tool on after switching the ignition on.
  2. Select "Vehicle Model" and "TPMS" on the GDS vehicle selection screen, then press "OK". [Recording Sensor ID]
    [Vehicle Name Input Initialization]
    [VIN Input Initialization]

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.