Hyundai Elantra CN7 Quiz

Front Wheel Hub and Steering Knuckle - Installation, Disassembly

In this manual: Front Wheel Hub and Steering Knuckle - Installation, Disassembly
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
2special tools

1. Installation is performed in the reverse order of removal.

ПРИМЕЧАНИЕ

1. Tighten the threaded connections of the parts listed below to the specified torque:

2. Перед установкой гайки крепления вала привода колеса установите шайбу выпуклой

2. Before installing the drive shaft nut, install the washer with the convex side facing outward, as shown in the illustration.

DISASSEMBLY

1. Remove the two brake disc mounting bolts, then remove the brake disc from the wheel hub.

2. Снимите стопорное кольцо подшипника ступицы.

2. Remove the hub bearing snap ring.

3. Установите специальный инструмент на ступицу колеса, как показано на рисунке.

3. Install the special service tool on the wheel hub, as shown in the illustration.

4. Turn the special service tool to remove the wheel hub from the steering knuckle.

5. Remove the special service tool and the dust cover.

6. С помощью специального инструмента извлеките внутреннюю обойму подшипника

6. Using the special service tool, remove the inner bearing race from the wheel hub.

7. С помощью специального инструмента (09495-33100 и 09517-29000) извлеките наружную

7. Using the special service tools (09495-33100 and 09517-29000), remove the outer bearing race from the steering knuckle.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.