Front Seat Belt Pretensioner Repair Procedures

Replacement

When installing or removing the belt, be careful not to damage the pretensioner.

1. 1
   Remove the front seat belt anchor (A).

   

   ? How to Disconnect the Anchor Seat Belt 1) Expose the red indicator pin (A) by pressing the slot with a pointed tool of O 1.5 mm, as shown in the illustration below. Be careful not to scratch the anchor cover with a pointed object when pressing the slot. 2) Insert a (-) screwdriver (4 mm) into the latch hole () and turn it clockwise. 3) Remove the connector by pulling the seat belt ( ). When connecting the anchor connector, secure it firmly until you hear a click.

2. 2
   Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
3. 3
   Remove the center pillar upper garnish. (Refer to Body Trim - "Center Pillar Garnish")
4. 4
   Loosen the upper front seat belt anchor mounting bolt, and remove the upper front seat belt anchor (A).

   Tightening torque: 39.2 ~ 54 N·m

   

5. 5
   Loosen the mounting bolts and remove the front seat belt center bracket (A).

   

6. 6
   Disconnect the connector (A), loosen the mounting bolts, and remove the front seat belt pretensioner (B).

   Tightening torque: 39.2 ~ 54 N·m

   [General Type]

   

   [Option Type]

   

7. 7
   Install in the reverse order of removal.

   After installing the front seat belt pretensioner, make sure the airbag indicator illuminates for approximately 6 seconds when the ignition is turned on, and then goes off. Make sure the connector is properly connected. Replace all damaged clips.