Hyundai Genesis DH Quiz
Automatic Transmission System (SBC)

Repair Procedures

In this manual: Automatic Transmission System (SBC)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
2steps
~12min
1/5difficulty
Done 0 of 2

End Of Line (EOL) Input
If a shock occurs during shifting or parts related to the transmission are replaced, End Of Line (EOL) must be performed. EOL is required in the following case.
  • Transaxle Assembly Replacement
  • TCM Replacement

EOL (Oil Pressure Characteristics) Input Procedure
  • When replacing the transmission assembly and TCM, perform the "Oil Pressure Characteristics Input" procedure using GDS.
  • Location of Oil Pressure Characteristics (Barcode)
  1. When replacing the transmission assembly.
    A. Perform the "Oil Pressure Characteristics Input" procedure.
    B. With internet access (automatic mode): Enter the transmission serial number.
    C. Without internet access (manual mode): Enter the oil pressure characteristics from the barcode.
    D. With Internet Access (Automatic Mode)
    E. Without Internet Access (Manual Mode)
  2. When replacing the TCM.
    A. Perform the "Oil Pressure Characteristics Save and Input" procedure.
    B. Perform the "Oil Pressure Characteristics Save" procedure.
    C. Perform the "Oil Pressure Characteristics Input" procedure.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.