Repair Procedures

Replacement

Wear gloves to avoid cutting your hands.

When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components. When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")
2. 2
   Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
3. 3
   Carefully remove the front door side weatherstrip.
4. 4
   Carefully remove the rear door body side weatherstrip.
5. 5
   Remove the front door scuff plate. (Refer to Interior Trim - "Front Door Scuff Trim".)
6. 6
   Remove the rear door scuff plate. (Refer to Interior Trim - "Rear Door Scuff Trim".)
7. 7
   Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
8. 8
   Remove the side cowl trim. (Refer to Interior Trim - "Side Cowl Trim")
9. 9
   Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")
10. 10
    Using a screwdriver or puller, remove the frame ID plug bracket (A).
11. 11
    Remove the accelerator pedal. (Refer to Engine Control / Fuel System - "Accelerator Pedal".)
12. 12
    Remove the floor carpet assembly (B).
13. 13
    Install in the reverse order of removal.

    Replace all damaged clips.

    

    1. Frame ID Plug 2. Floor Carpet Assembly

    3. Tunnel Pad