Steering Wheel Remote Control Repair Procedures

Inspection

1. 1
   Check the resistance between the terminals at each switch position (G).

   

   [G: Audio + Bluetooth (Standard Instrument Cluster)]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   MUTE	2,5	1.0 kΩ
   VOLUME UP		2.5 kΩ
   VOLUME DOWN		4.7 kΩ
   END		16.8 kΩ
   MODE		38.8 kΩ

   
   [G: Audio + Bluetooth (Super Vision Instrument Cluster)]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   SEEK UP	2,5	430 Ω
   SEEK DOWN		1.1 kΩ
   Mode		2.11 kΩ
   MUTE		3.11 kΩ
   VOLUME UP		4.61 kΩ
   VOLUME DOWN		6.81 kΩ
   END		18.91 kΩ
   MODE		40.91 kΩ

2. 2
   Check the resistance between the terminals at each switch position. (D)

   

   [D: Audio System + Trip Computer (Standard Cluster)]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   Trip Computer	2,5	330 Ω
   Re-close		550 Ω
   SEEK UP	3-4	430 Ω
   SEEK DOWN		1.1 kΩ
   Mode		2.11 kΩ

   
   [D: Trip Computer (Super Vision Cluster)]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   GROUP	2,5	330 Ω
   Down (▽)		550 Ω
   Down (▽)		880 Ω
   GOOD		1.44 kΩ

DEPOSIT

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the driver airbag module. (Refer to Restraints - "Driver Airbag Module and Clock Spring (DAB)")
3. 3
   Remove the steering wheel. (Refer to Steering System - "Steering Wheel")
4. 4
   Loosen the screws to remove the steering wheel rear cover. (B)

   

5. 5
   Disconnect all connectors and remove the wiring (A) from the steering wheel.

   

6. 6
   Remove the remote control switch assembly on the steering wheel (A) after loosening the screws.

   

   

   

   

   

REMEDY

1. 1
   Assemble the steering wheel remote control switch after connecting the connector.
2. 2
   Install the driver airbag module.