Hyundai i20 Quiz
Restraint

Repair Procedures

In this manual: Restraint
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
28steps
~168min
4/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 28

DEPOSIT

[Front BPT]
  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the door scuff plate. (Refer to Body group - Interior Trim.)
  3. Remove the center pillar trim. (Refer to Body group - Interior Trim.)
  4. Loosen the seat belt pretensioner mounting bolts (2 pcs) and remove the seat belt pretensioner.
  5. Disconnect the seat belt pretensioner connector (A).
  6. Disconnect the negative battery cable and wait at least three minutes before starting work.
  7. Remove the rear seat assembly. (Refer to Body - Rear Seat)
  8. Remove the luggage compartment side trim. (Refer to Body - Luggage Compartment Side Trim)
  9. Remove the rear pillar trim. (Refer to Body - "Rear Pillar Trim")
  10. Disconnect the rear seat belt pretensioner connector (B).
  11. Remove the rear seat belt pretensioner mounting bolts.
[Rear BPT]

REMEDY

[Front BPT]
  1. Remove the key from the ignition switch.
  2. Disconnect the negative battery cable and wait at least three minutes.
  3. Install the seat belt pretensioner bolts (A).
  4. Connect the seat belt pretensioner connector (B).

    Tightening torque: Bolt B: 39.2 ~ 54 N·m

  5. Install the center pillar trim. (Refer to Body group - Interior Trim.)
  6. Install the door scuff plate. (Refer to Body group - Interior Trim.)
  7. Connect the battery negative cable.
  8. After installing the seat belt pretensioner, confirm the system operates correctly:
    • Turn the ignition switch to ON; the SRS warning lamp should illuminate for approximately six seconds and then go off.
  9. Remove the key from the ignition switch.
  10. Disconnect the negative battery cable and wait at least three minutes.
  11. Install the rear seat belt pretensioner with the bolts (B).
  12. Connect the seat belt pretensioner connector (B).
  13. Install the rear pillar trim. (Refer to Body - Rear Pillar Trim)
  14. Install the luggage compartment side trim. (Refer to Body - Luggage Compartment Side Trim)
  15. Install the rear seat assembly. (Refer to Body - Rear Seat)
  16. Connect the battery negative cable.
  17. After installing the seat belt pretensioner, confirm the system operates correctly:
    • Turn the ignition switch to ON; the SRS warning lamp should illuminate for approximately six seconds and then go off.
[Rear BPT]

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.