Hyundai i20 Quiz
Heating, Ventilation and Air Conditioning

HEATER Repair Procedures

In this manual: Heating, Ventilation and Air Conditioning
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

  1. Measure the resistance between the terminals.
  2. If the measured resistance is not within specification, replace the blower resistor. (After removing the resistor)
    1. ML
    2. MX    		 3. DOWN
    4. TOP

REPLACEMENT

  1. Disconnect the negative (-) battery terminal.
  2. Remove the center fascia panel. (Refer to Instrument Panel - Center Fascia Panel)
  3. Disconnect the connector (A), then remove the blower resistor (B) after loosening the mounting screws.
  4. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.