Drive Shaft and Axle
Specifications
In this manual: Drive Shaft and Axle
~1min read
Specification
| ENGINE | M/T | Seal type | Max. angle allowed | ||
| Outer | Inner | Outer | Inner | ||
| Kappa 1.4 | MT/AT | MINET No. 22 | TI # 22 | 46,5° | 23° |
| Kappa 1.2 | MT | MINET # 21 | CTJ # 21 | 46,5° | 23° |
| UII-1.4 | MT | Pinion # 23 | TJG # 23 | 46,5° | 23° |
| UII 1.2 | MT | MINET No. 22 | TI # 22 | 46,5° | 23° |
| Kappa T-GDI | MT | MINET No. 22 | TI # 22 | 46,5° | 23° |
Tightening Torque
| Item | Tightening Torque (kgf·m) | ||
| N·m | kgf·m | lbf·ft | |
| Hub nuts | 107,9~127,5 | 11,0~13,0 | 79,6~94,0 |
| Drive shaft lock nut | 274,6~294,2 | 28,0~30,0 | 202,5~217,0 |
| Hub spacer kit | 98,1~117,7 | 10,0~12,0 | 72,3~86,8 |
| Lower arm ball joint | 58,8~70,6 | 6,0~7,2 | 43,4~52,1 |
| Tie rod end castle nut | 23,5~33,3 | 2,4~3,4 | 19,4~24,5 |
| Front caliper on steering knuckle | 78,4~98,0 | 8,0~10,0 | 57,8~72,3 |
| Rear caliper support | 63,7~73,5 | 6,5~7,5 | 47,0~54,2 |
| Rear hub of torsion beam axle | 49,0 - 58,8 | 5,0–6,0 | 36,1~43,3 |
Lubricants
| ENGINE | Lubricants | Quantity | |
| Kappa 1.2 TM | MINET | RBA | 90~100 g |
| T.J. | CW09-VX21 | 120~130 g | |
| Kappa 1.4 (TM/AT) | MINET | RBA | 90~100 g |
| T.J. | CW09-VX21 | 135~145 g | |
| UII 1.4 (TM) | MINET | RBA | 90~100 g |
| T.J. | VX-21 | 140~150 g | |
| UII 1.2 (TM) | MINET | RBA | 90~100 g |
| T.J. | CW09-VX21 | 135~145 g | |
| Kappa T-GDI | MINET | RBA | 90~100 g |
| T.J. | CW09-VX21 | 135~145 g | |
Test yourself
A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?