Using the Tire Mobility Kit

1. Remove the speed limit label (0) from the sealant bottle (1) and place it in a visible location in the vehicle (for example, on the steering wheel) so that the driver does not drive too fast.

2. Screw the flexible connecting hose (8) onto the fitting of the sealant bottle.

3. Unscrew the cap from the valve of the flat tire and screw the filler hose (2) from the sealant bottle onto the valve.

4. Insert the sealant bottle into the compressor housing (4) so that the bottle is in an upright position.

5. Make sure the compressor is off, position 0.

6. Plug the compressor power cord into the vehicle's power outlet.

7. Using the engine start/stop button or the ignition key set to ON, turn on the compressor and let it run for about 5 to 7 minutes to fill the tire with sealant until the correct pressure is reached (see Chapter 8, "Tires and Wheels"). The tire inflation pressure after filling is minimal and will be checked/corrected later.

Be careful not to overinflate the tire, and stay away from it during filling.

NOTE: Tire Pressure

Do not attempt to drive the vehicle if tire pressure is less than 29 psi (200 kPa). This may cause an accident due to sudden tire failure.

8. Stop the compressor.

9. Disconnect the hoses from the sealant bottle connector and the valve.

Place the Tire Mobility Kit in the storage compartment in the vehicle.

WARNING

Carbon Monoxide

Do not leave the vehicle with the engine running in poorly ventilated areas for a long time. This may lead to carbon monoxide poisoning and suffocation.