Hyundai Kona Quiz
Engine Electrical System

Battery Sensor Repair Procedures

In this manual: Engine Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
0102030405064N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Removal

  1. Disconnect the negative (-) battery cable.
  2. Turn the ignition off.
  3. Disconnect the negative (-) battery terminal (A). Battery negative (-) terminal nut tightening torque: 4.0–6 N·m
  4. Remove the battery sensor (B) after loosening the mounting bolt (A).

Installation

  1. Install in the reverse order of removal.

Battery Sensor Recalibration Procedure

After reconnecting the negative battery cable, the AMS function does not operate until the system stabilizes, approximately 4 hours. If the negative (-) battery cable is disconnected from the battery during repair work on a vehicle equipped with AMS, the battery sensor recalibration procedure must be performed after the repair work is completed.
  1. Turn the ignition switch ON and OFF.
  2. Park the vehicle for approximately 4 hours with the hood closed and all doors closed.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.