Hyundai Kona Quiz
Propeller Shaft and Axle (2WD-FF)

BJ Boot Repair Procedures

In this manual: Propeller Shaft and Axle (2WD-FF)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~65min
3/5difficulty
1special tools
Done 0 of 10

Removal

  1. Remove the front drive shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  3. Remove the dynamic damper. (Refer to Drive Shaft Assembly - "Dynamic Damper")
  4. Using pliers or a flat-tip (-) screwdriver, remove the BJ boot bands (A).
  5. Remove the BJ boot.

Installation

  1. Install in the reverse order of removal.
  2. Using SST (09495-3K000), secure the BJ boot bands.
  3. Install the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  4. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  5. Check the alignment. (Refer to Suspension System - "Alignment")

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.