Hyundai Kona Quiz
Propeller Shaft and Axle (2WD-FF)

Dynamic Damper Repair Procedures

In this manual: Propeller Shaft and Axle (2WD-FF)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
13steps
~83min
4/5difficulty
1special tools
Done 0 of 13

Removal

  1. Remove the front drive shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  3. Remove both dynamic damper bands (B) from the dynamic damper (A).
  4. Secure the drive shaft (A) in a vise (B), as shown in the illustration.
  5. Apply soapy powder to the shaft to prevent damage between the shaft splines and the dynamic damper when the dynamic damper is removed.
  6. Carefully separate the dynamic damper (A) from the shaft (B).

Installation

  1. Apply soapy powder to the shaft to prevent damage between the shaft splines and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper bands.
  4. Using SST (09495-39100), secure the TJ boot clamps.
  5. Install the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  6. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  7. Check the front wheel alignment. (Refer to Suspension System - Alignment)

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.