Hyundai Kona Quiz
Engine Mechanical System

Engine Mount Repair Procedures

In this manual: Engine Mechanical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
20steps
~120min
4/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 20

Removal and Installation

Rod Bracket
  1. Remove the engine cover. (Refer to Engine and Transaxle Assembly - Engine Cover)
  2. Remove the roller rod bracket (A). Tightening torque: Bolt (B): 107.9–128 N·m Bolts (C): 49.0–64 N·m
  3. Remove the roller rod bracket (A).

    Tightening Torque: 49.0–69 N·m

  4. Install in the reverse order of removal.
  5. Remove the engine compartment cover. (Refer to Engine and Transaxle Assembly - "Engine Compartment Under Cover")
  6. Place a jack against the edge of the upper oil pan to support the engine.
  7. Remove the engine mount bracket (A). Tightening torque: Nut (B): 78.5–98 N·m N·m; Bolt (C), Nut (D): 58.8–74 N·m N·m
  8. Remove the coolant reservoir. (Refer to Cooling System - "Reservoir")
  9. Remove the engine mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  10. Install in the reverse order of removal.
  11. Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")
  12. Remove the battery. (Refer to Engine Electrical System - "Battery")
  13. Remove the ECM. (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
  14. Remove the battery tray. (Refer to Engine Electrical System - "Battery")
  15. Remove the engine room cover. (Refer to "Engine Room Under Cover" - "Engine Room Under Cover")
  16. Install the jack to the edge of the transaxle.
  17. Remove the service cover (A).
  18. Remove the transmission mounting bolts (A).

    Tightening torque: 107.9–128 N·m

  19. Remove the transaxle mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  20. Install in the reverse order of removal.
Engine Mount Bracket / Transaxle Mount Bracket

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.