Hyundai Kona Quiz
Body (Interior and Exterior)

Front Door Window Glass Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~48min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Replacement

  1. Remove the front door trim. (Refer to Front Door - "Front Door Trim")
  2. Remove the front door belt inside the weatherstrip (A).
  3. After removing the mounting screws, remove the front door handle full support bracket (A).
  4. Disconnect the front door speaker connector (A).
  5. Remove the front door trim cover seal (A).
  6. While holding the power window switch, pull it down until the glass mounting bolt is visible through the plug hole.
  7. Loosen the mounting bolt and remove the front door glass (A) by tilting it to one side.

    Tightening torque: 7.8–11.8 N·m

  8. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.