Hyundai Kona Quiz
Body (Interior and Exterior)

Front Seat Frame Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Replacement

  1. Remove the front seat rear cover. (Refer to Front Seat - Front Seat Rear Cover).
  2. Remove the front seat cushion cover. (Refer to Front Seat - Front Seat Cushion Cover)
  3. Remove the SAB module. (Refer to Passive Safety System - "Side Airbag Module (SAB)").
  4. Remove the seat track support assembly. (Refer to Body Electrical System - "Seat Track Support Assembly").
  5. Loosen the mounting bolts and separate the front seatback frame assembly (A) from the front seat cushion frame assembly (B).

    Tightening Torque: 44.1–54 N·m

  6. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.