Hyundai Kona Quiz
Body (Interior and Exterior)

Glove Box Housing Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
Done 0 of 6

Replacement

  1. Remove the side cowl trim. (Refer to Interior Trim - "Side Cowl Trim")
  2. Remove the glove box. (Refer to Crash Pad - "Glove Box")
  3. Remove the garnish assembly [RH] (Refer to Crash Pad - "Crash Pad Garnish Assembly [RH]").
  4. Loosen the mounting screws, nut and bolts, then remove the glove box housing cover (A).
  5. Disconnect the glove box lamp connector (A) and the lamp switch connector (B).
  6. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.