Hyundai Kona Quiz
Body Electrical System

Lumbar Support Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
12steps
~72min
3/5difficulty
Done 0 of 12

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the seatback. (Refer to Body - "Front Seatback Cover")
  4. Disconnect the lumbar support motor connector (A).
  5. Remove the lumbar support assembly (C) after disconnecting the seat rear spring (A) and cable (B).

Installation

  1. Install the lumbar support assembly.
  2. Install the seatback trim.
  3. Install the front seat assembly.

Inspection

Lumbar Support Motor
  1. Disconnect the connectors for each motor. [Lumbar Support Motor]
  2. Connect the battery directly to the motor terminals and check whether the motors operate smoothly.
  3. Reverse the connections and check that the motor rotates in the opposite direction.
  4. If there are any abnormalities, replace the motors.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.