Hyundai Kona Quiz
Body Electrical System

Power Seat Control Switch Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

Seat Control Switch
  1. When the power seat switch is in each position, make sure continuity exists between the terminals below. If continuity does not match the specification, replace the power seat switch.
    [Power Seat Control Switch]

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front seat outer cover. (Refer to Body - "Front Seat Outer Cover")
  3. Remove the power seat control switch (A) after loosening the screws.

Installation

  1. Install the power seat control switch after connecting the connector.
  2. Install the front seat outer cover.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.