Hyundai Kona Quiz
Body Electrical System

Power Seat Motor Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

Power seat motor
  1. Disconnect the connector for each motor. [Slide Motor]
    [Rear Height Motor]
    [Front Height Motor]
    [Tilt Motor]
    [Lumbar Support Motor]
  2. Connect the battery directly to the motor terminals and check whether the motors operate smoothly.
  3. Reverse the connections and check that the motor rotates in the opposite direction.
  4. If there are any abnormalities, replace the motors. [Driver/Passenger]
[Tilt Motor Limit Switch]
  1. Disconnect the limit switch and check the limit switch.
  2. Check the circuit between the terminals for continuity.
  3. Make sure the seat operates normally in the reverse direction after the maximum operation.
  4. If out of specification, replace the limit switch.

Remove

Front Seat
  1. Disconnect the battery terminals.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.