Hyundai Kona Quiz
Brake System

Parking Brake Switch Repair Procedures

In this manual: Brake System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
5steps
~30min
2/5difficulty
010203040502.92N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Release the parking brake.
  3. Remove the floor console assembly. (Refer to Body - "Floor Console".)
  4. Disconnect the parking brake switch connector (A).
  5. Loosen the screw and remove the parking brake switch (A).

    Tightening torque : 1.96–2.9 N·m

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.