Hyundai Kona Quiz
Body Electrical System

Power Window Motor Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
9steps
~54min
3/5difficulty
Done 0 of 9

Inspection

Front Power Window Motor
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Disconnect the motor connector (A) from the motor.
  4. Connect terminals No. 1 and No. 2 to battery voltage (12 V) and check that the motor operates smoothly when connecting the terminals as shown below. [Safety Window Motor]
  5. Connect the motor terminals directly to battery voltage (12 V) and check that the motor operates smoothly. Then reverse the polarity and check that the motor operates smoothly in the opposite direction. If operation is abnormal, replace the motor. [Standard Power Window]
  6. Disconnect the negative (-) battery terminal.
  7. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  8. Disconnect the motor connector from the motor.
  9. Connect motor terminals No. 1 and No. 2 directly to battery voltage (12 V) and check that the motor operates smoothly. If operation is abnormal, replace the motor. [Standard Power Window]
Rear Power Window Motor

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.