Hyundai Kona Quiz
Body Electrical System

Power Window Switch Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
22steps
~132min
4/5difficulty
Done 0 of 22

Inspection

[Driver Power Window Switch]
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver door trim panel. (Refer to Body - "Front Door Trim Panel")
  3. Disconnect the power window switch connector (A) from the door trim panel.
  4. Check the continuity between the terminals at each switch position as shown below. [Window Switch Inspection]
    [Power Door Lock Switch Inspection]
    [Power Window Lock Switch Inspection]
  5. Disconnect the negative (-) battery terminal.
  6. Remove the front door auxiliary trim. (Refer to Body - "Front Door Trim")
  7. Disconnect the power mirror switch connector from the door trim.
  8. Check the continuity between the terminals at each switch position as shown below.
  9. Disconnect the negative (-) battery terminal.
  10. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  11. Disconnect the power mirror switch connector from the door trim.
  12. Check the continuity between the terminals at each switch position as shown below. [Rear Window Switch Inspection]
[Auxiliary Power Window Switches] Rear Power Window Switch

Removal

Driver/Passenger Power Window Switches
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Remove the power window switch assembly (A).
  4. Disconnect the negative (-) battery terminal.
  5. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  6. Disconnect the connector, then remove the power window switch assembly.
Rear Power Window Switch

Installation

Driver/Passenger Power Window Switches
  1. Install the power window switch assembly.
  2. Install the front door trim panel after connecting the connector.
  3. Install the power window switch assembly.
  4. Install the rear power window switch.
Rear Power Window Switch

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.