Hyundai Kona Quiz
Body (Interior and Exterior)

Rear Seat Back Trim Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
21steps
~131min
5/5difficulty
1special tools
Done 0 of 21

Replacement

[LH]

  1. Remove the rear seat assembly [LH]. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Press the stopper pins and remove the rear seat headrest (A).
  3. Loosen the mounting screws and remove the rear seat folding trim (A).
  4. Using a screwdriver or a remover, remove the rear seat belt center cover (A).
  5. Loosen the mounting screw and remove the rear seat back latch cover (A).
  6. Using a screwdriver or remover, remove the rear seat back cover (A).
  7. Using a screwdriver or remover, remove the cover (A).
  8. Pull out the rear seat headrest guides (A) while pressing both sides of the lower part of the guides, and remove them.
  9. Remove the rear seat back trim assembly (A) from the rear seat back frame.
  10. Remove the hook-and-loop tape (A) and ring clips (B) inside the rear seat cushion cover, then remove the seat cushion cover (C).
  11. To install, reverse the removal procedure.

[RH]

  1. Remove the rear seat assembly [RH]. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Press the stopper pins and remove the rear seat headrest (A).
  3. Using a screwdriver or remover, remove the cover (A).
  4. Loosen the mounting screw and remove the rear seat folding trim (A).
  5. Loosen the mounting screw and remove the rear seat back latch cover (A).
  6. Using a screwdriver or remover, remove the rear seat back cover (A).
  7. Pull out the rear seat headrest guides (A) while pressing both sides of the lower part of the guides, and remove them.
  8. Remove the rear seat back trim assembly (A) from the rear seat back frame.
  9. Remove the hook-and-loop tape (A) and ring clips (B) inside the rear seat cushion cover, then remove the seat cushion cover (C).
  10. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.