Hyundai Kona Quiz
Body (Interior and Exterior)

Rear Seat Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
0102030405031.423N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Replacement

[Rear Seat Cushion Assembly]
  1. Remove the luggage compartment cover panel (A).
  2. Remove the luggage compartment center floor tray assembly (A).
  3. Lift the rear seat back (A) by pulling the lever.
  4. Loosen the mounting bolts and remove the rear seat cushion assembly (A).

    Tightening Torque: 21.6–31 N·m

  5. To install, reverse the removal procedure.
  6. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  7. Remove the center seat belt (A) by pressing it with an awl.
  8. Lift the rear seat back (A) by pulling the lever.
  9. Loosen the mounting bolts and remove the rear seat back assembly (A).

    Tightening Torque: 21.6–31 N·m

  10. To install, reverse the removal procedure.
[Rear Seat Back Assembly]

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.