Body Electrical System
Speaker Repair Procedures
In this manual: Body Electrical System
18steps
~108min
4/5difficulty
Done 0 of 18
Inspection
- Speaker Troubleshooting
- Basic Speaker Inspection: Check the sound from the speaker, making sure the speaker mounting screws are removed and the wiring connector is connected, to eliminate vibration transmitted from the body panels and surrounding parts.

- Troubleshooting
No Symptom Inspection/Remedy 1 Rattling Noise - Before replacing the speaker, make sure the mounting screw is installed properly.
- After reinstalling the speaker, make sure that no rattling sound is heard.
- If the rattling sound is heard again, replace the speaker with a new one.
2 Noise - Check whether the wiring connector is connected properly. If not, connect the wiring connector.
- In the case of radio static, check for noise from the CD player.
- If noise is heard when the radio and CD are turned on, replace the speaker with a new one.
3 Poor Performance Check the wiring connection between the battery and speaker - Before replacing the speaker, inspect the wiring and connections in the speaker circuit.
- Check the power supply to the speaker and the resistance, then check the sound quality.

- If the speaker performs poorly, replace it with a new one.
- Basic Speaker Inspection: Check the sound from the speaker, making sure the speaker mounting screws are removed and the wiring connector is connected, to eliminate vibration transmitted from the body panels and surrounding parts.
Removal
[Front Door Speakers]- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel. (Refer to Body - "Front Door Trim")
- Remove the front door speaker (B) after disconnecting the connector (A) and loosening the screws.

- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel. (Refer to Body - "Front Door Trim")
- Remove the tweeter (A) after loosening the screws.

- Disconnect the negative (-) battery terminal.
- Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
- Remove the rear door speaker (B) after disconnecting the connector (A) and loosening the screws.

Installation
Front Door Speaker- Install the front door speaker.
- Install the front door trim panel.
- Connect the negative (-) battery terminal.
- Install the tweeter in the front door.
- Install the front door trim panel.
- Connect the negative (-) battery terminal.
- Install the rear door speaker.
- Install the front door trim panel.
- Connect the negative (-) battery terminal.
Test yourself
A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?