Hyundai Palisade Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

Check this by performing the procedure below to confirm that the ECM operates normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor.
  3. Direct light at the rear view sensor.
  4. The ECM should darken as soon as the rear view sensor detects light.
    Hyundai Palisade. Repair procedures
    If this test is performed during the daytime, the ECM may darken as soon as the front sensor is covered.
  5. When reverse gear is engaged, the ECM must not dim. When light is directed at both the front and rear sensors, the ECM must not dim.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the mirror wiring covers (A) and (B).
    Hyundai Palisade. Repair procedures
  3. Remove the mirror mounting screw and connector (A).
  4. Remove the mirror by pulling it up in the direction of the arrow.
    Hyundai Palisade. Repair procedures
    Do not damage the mounting bracket when removing the mirror.
    Hyundai Palisade. Repair procedures

Installation

  1. Install the mirror, making sure the mounting bracket is not damaged.
  2. Install the mirror wiring cover after reconnecting the connector and tightening the screw.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.