Body (Interior and Exterior)

Headliner Assembly

16steps
~96min
4/5difficulty
Done 0 of 16

Components and Component Location

Component Location

Hyundai Palisade. Components and components location
1. Headliner assembly

Repair Procedures

Replacement

Hyundai Palisade. Repair procedures
  • When removing with a flat-blade screwdriver or puller, wrap the tool with protective tape to prevent damage to the components.
  • Wear gloves to avoid cutting your hands.
Hyundai Palisade. Repair procedures
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the front seat. (Refer to Front Seat - "Front Seat Assembly")
  2. Remove the rear seat. (Refer to Rear Seat - "Rear Seat Assembly")
  3. Remove the front pillar trim. (Refer to Body Interior Trim - "Front Pillar Trim")
  4. Remove the upper center pillar garnish. (Refer to Interior Trim - "Center Pillar Garnish")
  5. Remove the rear pillar trim. (Refer to Body Interior Trim - "Rear Pillar Trim")
  6. Remove the sun visor and holder. (Refer to Headliner - "Sun Visor")
  7. Remove the assist grip. (Refer to Headliner - "Assist Grip")
  8. Remove the overhead console lamp. (Refer to Body Electrical System - "Overhead Console Lamp")
  9. Remove the room lamp. (Refer to Body Electrical System - "Room Lamp")
  10. Disconnect the ECM mirror connector. (Refer to Body Electrical System - "Electrochromic Rear View Mirror")
  11. Disconnect the headliner main connector (A) from the front pillar section [LH].
    Hyundai Palisade. Repair procedures
    [RH]
    Hyundai Palisade. Repair procedures
  12. Remove the headliner clip and remove the headliner assembly (A).
    Hyundai Palisade. Repair procedures
  13. Disconnect the various headliner connectors (A) [Front].
    Hyundai Palisade. Repair procedures
    [Center]
    Hyundai Palisade. Repair procedures
    [Rear]
    Hyundai Palisade. Repair procedures
  14. Remove the headliner assembly (A) from the vehicle through the rear door.
    Hyundai Palisade. Repair procedures
  15. Remove the headliner wire harness from the headliner (A).
    Hyundai Palisade. Repair procedures
    • Be careful not to damage the headliner wire harness during removal.
    Hyundai Palisade. Repair procedures
    Hyundai Palisade. Repair procedures
    1. When installing the headliner wire harness to the headliner, apply hot melt adhesive continuously using a hot melt adhesive gun.
    2. Place the noise insulation pad on the headliner to prevent noise.
  16. To install, reverse the removal procedure.
    Hyundai Palisade. Repair procedures
    • Make sure the connector is properly connected.
    • Replace all damaged clips.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.