Wheel

Repair Procedures

Hub Nut Tightening Sequence

1. 1
   Tighten the hub nuts as follows.

   Tightening torque: 107.9–128 N·m

   

   When using an impact wrench, the final tightening torque must be checked with a torque wrench.

   If the vehicle is started within 19 minutes after replacing a wheel of a stopped vehicle, the TPMS malfunction indicator on the instrument cluster illuminates. The above symptom occurs due to a communication failure between the BCM and the replaced TPMS ID. This communication failure indicator turns off 19 minutes after the vehicle is stopped, through the BCM automatic TPMS ID learning process. (If the vehicle is driven after being stopped for more than 19 minutes, the indicator turns off automatically.)

2. 2
   Raise the vehicle.
3. 3
   Measure the wheel runout using a dial indicator as shown in the illustration below.

   Run out	Aluminum
   Radial mm (in)	Below 0.3 (0.0118)
   Lateral mm (in)	Below 0.3 (0.0118)

4. 4
   If the measured value exceeds the specified value, replace the wheel.