Hyundai Tucson Quiz
Body Work (Interior and Exterior)

Rear bumper cover

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

COMPONENT LOCATION

1. Rear Bumper Cover

Repair Procedures

REPLACEMENT

  1. Remove the combination lamp cover (A).
  2. After loosening the mounting screws, remove the rear combination lamps (A).
  3. Disconnect the rear combination lamp connector (A).
  4. Loosen the upper rear bumper mounting.
  5. Loosen the lower rear bumper mounting clips.
  6. Loosen the mounting bolts.
  7. Disconnect the rear bumper connector (A).
  8. After loosening the pin-type retainers and screws inside the rear bumper, disconnect the side portion of the rear bumper.
  9. Remove the rear bumper cover (A).
  10. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.