Hyundai Tucson Quiz
Body Work (Interior and Exterior)

Rear bumper bracket

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
5steps
~30min
2/5difficulty
Done 0 of 5

Components and Component Location

COMPONENT LOCATION

1. Rear Bumper Bracket

Repair Procedures

REPLACEMENT

  1. Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")
  2. Disconnect the rear bumper crossmember harness connector (A).
  3. Loosen the mounting screws and remove the smart key antenna (A).
  4. After releasing the clips, remove the rear bumper crossmember (A).
  5. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.