Hyundai Tucson Quiz
Body Electrical System

Speaker Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
32steps
~192min
5/5difficulty
Done 0 of 32

Inspection

Speaker Troubleshooting

  1. BASIC INSPECTION: Loosen the screws to avoid any interference from the gasket, housing, and surrounding parts, then remove the speaker. After removing the speaker, check the speaker sound quality with the connector connected.
  2. Check by each cause
    1. Abnormal vibration
      • Make sure the mounting screws are tightened properly before replacing the speaker.
      • Reinstall the speaker and check whether the symptom has disappeared. OK.
      • If the symptom does not disappear, replace the speaker with a new one.
    2. Noise
      • Make sure the speaker connector is connected correctly, and reconnect it if necessary.
      • If noise is heard in radio mode, switch to CD playback mode.
      • If there is noise in both modes, replace the speaker with a new one.
    3. Malfunction
      • Check the positive (+) and negative (-) terminals of the speaker with an ohmmeter.
      • If the measured resistance is within the specified value shown below, the speaker is operating normally.
      • If the measured resistance differs from the specified value, replace the speaker.

DEPOSIT

Front Door Speaker
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Remove the front door speaker (B) by disconnecting the connector (A) and loosening the nuts.
  4. Disconnect the negative (-) battery terminal.
  5. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  6. Remove the tweeter (A) after loosening the screws.
  7. Disconnect the negative (-) battery terminal.
  8. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  9. Remove the rear door speaker (B) by disconnecting the connector (A) and loosening the nuts.
  10. Disconnect the negative (-) battery terminal.
  11. Using a scraper or puller, remove the center speaker cover (A).
  12. Remove the center speaker (A) by disconnecting the connector and loosening the screws.
  13. Disconnect the negative (-) battery terminal.
  14. Remove the right luggage side trim. (Refer to Body - "Luggage Side Trim")
  15. Remove the subwoofer (A) by disconnecting the connector (B) and loosening the bolts and screw.
Front Door Tweeter, Rear Door Speaker, Center Crash-Pad Speaker, Subwoofer

REMEDY

Front Door Speaker
  1. Install the front door speaker.
  2. Install the front door trim panel.
  3. Connect the negative (-) battery terminal.
  4. Install the tweeter in the front door.
  5. Install the front door trim panel.
  6. Connect the negative (-) battery terminal.
  7. Install the rear door speaker.
  8. Install the rear door trim panel.
  9. Connect the negative (-) battery terminal.
  10. Install the center speaker.
  11. Install the center speaker cover protective pad.
  12. Connect the negative (-) battery terminal.
  13. Install the subwoofer.
  14. Install the right trunk side trim.
  15. Connect the negative (-) battery terminal.
Front Door Tweeter, Rear Door Speaker, Center Crash-Pad Speaker, Auxiliary Low-Frequency Speaker

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.