AVN Remote Control

Components and Component Location

COMPONENTS

1. Switch the control to the left distance (audio + hands-free).

2. Remote control switch (Cruise control + trip computer)

Circuit Diagrams

Wiring Diagram

[Audio]

[Audio + Bluetooth]

[Audio/Bluetooth/Voice]

[Trip Computer]

[Trip Computer + Cruise Control]

Repair Procedures

Inspection

1. 1
   Check the resistance between the terminals at each switch position (G).

   

   [G: Audio + Hands-free]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   SEEK UP	2,5	430 Ω
   SEEK DOWN		1.11 kΩ
   Mode		2.11 kΩ
   MUTE		3.11 kΩ
   VOL (-)		4.61 kΩ
   VOL (-)		6.81 kΩ
   VOICE		10.71 kΩ
   MODE		18.91 kΩ
   END		40.91 kΩ

2. 2
   Check the resistance between the terminals at each switch position. (D)

   

   [D: Trip Computer + Cruise Control]

   With switch	CONNECTOR Thick Head	Resistance (±5%)
   CANCEL	3,5	330 Ω
   SET/-		550 Ω
   RES/+		880 Ω
   CRUISE ON/OFF		1.44 kΩ
   GROUP	2,5	550 Ω
   Trip A (Daily Odometer) High		880 Ω
   Trip B (Low) Odometer		1.44 kΩ
   Enter		2.54 kΩ

DEPOSIT

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the steering wheel assembly. (Refer to Steering System – Steering Wheel)
3. 3
   Remove the screws from the rear cover of the steering wheel (A).

   

4. 4
   Disconnect the remote control connector on the steering wheel (A).

   

5. 5
   Remove the steering wheel remote control (A) after loosening the screw.

   

REMEDY

1. 1
   Install the steering wheel remote control and cover after connecting the connector.
2. 2
   Install the steering wheel and the driver airbag module.
3. 3
   Connect the negative (-) battery terminal.