Fluid

Components and Component Location

Component location

Repair Procedures

MAINTENANCE ADJUSTMENT PROCEDURE

ATF Level Check

1. 1
   Remove the eye bolt (A).
2. 2
   Add 700 cc of ATF SP-IV through the ATF injection port.

   

3. 3
   Start the engine. (Do not apply the brake and accelerator at the same time.)
4. 4
   Make sure the oil temperature sensor temperature is within 50 ~ 60 °C using GDS.
5. 5
   Slowly move the shift lever from "P" to "D", then from "D" to "P", and repeat this at a slow pace.
6. 6
   Raise the vehicle, then remove the engine undercover. (Refer to Engine Mechanical System - "Engine Compartment Under Cover")
7. 7
   Remove the ATF level check plug (A) from the valve body cover.

   

8. 8
   If ATF flows from the level plug in a thin, steady stream, the ATF level is normal. Then complete the procedure and tighten the ATF level check plug.
9. 9
   Install the under cover. (Refer to Engine Mechanical System - "Engine Compartment Under Cover")
10. 10
    Lower the vehicle using the hoist, then tighten the eye bolt.

    Eye bolt tightening torque: 4.9 ~ 5.9 N·m

REPLACEMENT

1. 1
   Raise the vehicle, then remove the engine undercover. (Refer to Engine Mechanical System - "Engine Compartment Under Cover")
2. 2
   Remove the drain plug (A) and reinstall it after the ATF has been completely drained.Drain plug tightening torque: 33.3 ~ 43 N·m

   

3. 3
   Lower the vehicle using the hoist and remove the eye bolt (B).
4. 4
   Add approximately 5 liters of ATF through the filler hole.

   

5. 5
   Check the ATF level. (Refer to Hydraulic System - "Fluid")
6. 6
   Then complete the ATF level check procedure and install the under cover. (Refer to Engine Mechanical System - "Engine Compartment Under Cover")
7. 7
   Lower the vehicle using the hoist, then tighten the eye bolt.

   Eye bolt tightening torque: 4.9 ~ 5.9 N·m