Hyundai Tucson LM Quiz
Drive Shaft and Axle

Dynamic Damper Repair Procedures

In this manual: Drive Shaft and Axle
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
13steps
~83min
4/5difficulty
1special tools
Done 0 of 13

Removal

  1. Remove the front drive shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  3. Remove both dynamic damper bands (B) from the dynamic damper (A).
  4. Secure the drive shaft (A) in a vise (B), as shown in the illustration.
  5. Apply soap powder to the shaft to prevent damage between the shaft splines and the dynamic damper when the dynamic damper is removed.
  6. Carefully separate the dynamic damper (A) from the shaft (B).

Installation

  1. Apply soap powder to the shaft to prevent damage between the shaft splines and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper band (A).
  4. Using SST (09495-3K000), secure the TJ boot bands (B).

    Clearance (A): 2.0 mm (0.0787 in) or less

  5. Install the TJ joint assembly. (Refer to Drive Shaft Assembly – "TJ Joint")
  6. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  7. Check the front alignment. (Refer to Suspension System - "Front Wheel Alignment")

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.