Front Washer Motor Repair Procedures

Inspection

1. 1
   After connecting the washer motor to the reservoir, fill the reservoir with water.

   Before filling the reservoir with water, check the filter for foreign material or contamination. If necessary, clean the filter.

2. 2
   Connect the battery positive (+) cable to terminal 1 and the battery negative (-) cable to terminal 2, respectively.
3. 3
   Make sure the motor operates normally, the washer motor runs, and water is sprayed from the front nozzles.
4. 4
   If abnormal, replace the washer motor.

   

   No	Description	No	Description
   1	Ground	2	Windshield washer (+)

   
   

   

Removal

When servicing the washer pump, be careful not to damage the washer pump seal. Do not operate the washer pump until the washer reservoir is filled. Failure to do so may cause premature pump failure.

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the front bumper cover. (Refer to Group BD - "Front Bumper")
3. 3
   Remove the washer hose (A) and disconnect the washer motor connector (B).

   

4. 4
   Remove the front washer motor (A).

   

5. 5
   Remove the rear washer motor (A).

   

6. 6
   Remove the washer tank (B) by loosening the bolts (A).

   

Installation

1. 1
   Assemble the washer reservoir.

   Before installing the washer motor, check the filter for foreign material or contamination. If necessary, clean the filter.

2. 2
   Connect the washer motor connectors and washer hoses.
3. 3
   Install the front and rear washer motors.
4. 4
   Install the front and rear washer nozzles.

   Tightening torque (bolt): 3 ~ 5 N·m

5. 5
   Install the front bumper cover.