Hyundai Tucson LM Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

Check this by performing the procedure below to confirm that the ECM operates normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor.
  3. Direct light at the rear view sensor.
  4. The ECM should darken as soon as the rear view sensor detects light.
    If this test is performed during the daytime, the ECM may darken as soon as the front sensor is covered.
  5. When reverse gear is engaged, the ECM should not darken. If light is directed at both the front-facing and rear-facing sensors, the ECM should not darken.

Removal

  1. Remove the mirror wiring cover (A).
  2. Remove the mirror mounting screw (A) and the connector (B).
  3. Remove the mirror (A) by pulling up in the direction of the arrow.
    Do not damage the mounting bracket when removing the mirror.

Installation

  1. Install the mirror, making sure the mounting bracket is not damaged.
  2. Install the mirror wiring cover after reconnecting the connector and tightening the screw.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.