Hyundai Tucson LM Quiz
Engine Mechanical System

Water Temperature Control Assembly Repair Procedures

In this manual: Engine Mechanical System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal and Installation

  1. Drain the engine coolant so that the level is below the water temperature control assembly.
  2. Remove the air cleaner assembly. (Refer to Engine Room Air Cleaner Assembly in this group)
  3. Disconnect the upper radiator hose (A).
  4. Disconnect the heater hose (A).
    When installing the heater hoses, install them as shown in the illustrations.
  5. Disconnect the bypass hose (A) and throttle body coolant hose (B).
  6. Remove the water temperature control assembly (A) with the O-ring (B).

    Tightening torque: 9.8 ~ 11.8 N·m

  7. Installation is the reverse of removal.
    • Install a new O-ring.
    • Clean the O-ring contact surface and install the O-ring after wetting it with water.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.