Lowering the Windshield

1. 1
   Before performing the following steps:

   • If your vehicle is equipped with a Soft Top, the top MUST be lowered and the door frames must be removed before lowering the windshield.
   • If your vehicle is equipped with a Hard Top, the freedom panels MUST be removed before lowering the windshield.
   • Refer to the following instructions for additional information:
   • • Lowering the Soft Top
     • Door Frame
     • Freedom Panels
2. 2
   Manually remove the protective caps from the hex bolts of the windshield wiper arms.

   

   Step Two

3. 3
   Using the supplied 15 mm socket, remove the two hex bolts and remove the wiper arm.
4. 4
   Move inside the vehicle and lower both sun visors.
5. 5
   Using the supplied Torx #40 screwdriver, remove the four Torx screws located along the inside of the windshield.

   

   Step 5

   1. External Torx Screws

   2. Internal Torx Screws

   NOTE:

   Keep all fasteners in their original threaded holes and tighten them to secure them.

6. 6
   Carefully lower the windshield until it rests on the stop bumpers (if equipped).

   

   Step Six

   1. Washer Nozzle

   2. Bumper

   3. Strap

7. 7
   Secure the windshield by routing the strap through the loops on both sides of the hood and on the windshield frame. Tighten the strap to hold the windshield in place.

ACC/FCW Sensor Protective Cover — If Equipped

Your vehicle may be equipped with a protective cover that is used whenever the windshield is folded down to protect the Adaptive Cruise Control (ACC)/Forward Collision Warning (FCW) sensor. To install the cover, follow the instructions below:

1. 1
   Secure the top of the cover so that it loops over the header.
2. 2
   Rotate the cover down and press it so that it covers the opening.
3. 3
   Make sure the cover is securely fastened and installed correctly.

NOTE:

Be sure to remove the cover before returning the windshield to the upright position. Store the cover in the cargo area.

Cleaning Instructions

While the windshield is folded down, dust and dirt may accumulate on the cover and block the lens. Use a microfiber cloth to clean the camera lens, module, and inner cover, taking care not to damage or scratch the module.