Kawasaki Ninja ZX-10R Quiz
Wheels/Tires

Axle Inspection

In this manual: Wheels/Tires
General Information — 26Periodic Maintenance — 66Fuel System (DFI) — 79Cooling System — 28Engine Top End — 51Clutch — 24Engine Lubrication System — 28Engine Removal/Installation — 5Crankshaft/Transmission — 65Wheels/Tires — 22Final Drive — 17Brakes — 54Suspension — 36Steering — 17Frame — 40Electrical System — 104Self-Diagnosis System — 112Appendix — 10
~1min read
  • Remove the front and rear axles (see Front/Rear Wheel Removal).
  • Visually inspect the front and rear axle for damages.

If the axle is damaged or bent, replace it.

  • Place the axle in V blocks that are 100 mm (3.94 in.) [A] apart, and set a dial gauge [B] on the axle at a point halfway between the blocks. Turn [C] the axle to measure the runout. The difference between the highest and lowest dial readings is the amount of runout.

If axle runout exceeds the service limit, replace the axle.

Axle Inspection

Axle Runout/100 mm (3.94 in.) Standard: TIR 0.03 mm (0.0012 in.) or less

Service Limit: TIR 0.2 mm (0.008 in.)

Test yourself

A quick Kawasaki Ninja ZX-10R quiz: every answer comes with an explanation and a link to the manual page.