US, CA and CAL Models

1. Hold the water hose [A]. Insert the tab into the slot.

2. Hold the water hose [B]. Insert the tab into the slot.

3. Water Hose Fitting on Cylinder Head

4. Heat Insulation Rubber Plate

5. Run the crankshaft sensor lead and the oil pressure switch lead into the slot, and hook the slot on the grommet of the crankshaft sensor [C].

6. Right Heat Insulation Rubber Plate

7. Run the crankshaft sensor lead to inside of the rubber plate.

8. Run the water hose [D], and hook the water hose clamp screw [E].

9. Insert the tabs into the slots.

10. Place this portion to inside of the right heat insulation rubber plate.

11. Thermostat

12. Run the gear position switch lead here.

13. Insert the tabs into the slots.

14. Left Heat Insulation Rubber Plate