Kia Cadenza VG Owner's Manual Quiz
Body (Interior and Exterior)

Mirror Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
0102030405010.88N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Replacement

Outside Rearview Mirror Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  1. Using a screwdriver or a trim remover, remove the front door frame inside cover (A).
  2. Disconnect the outside rear view mirror connector (A).
  3. Loosen the mounting nuts, then remove the outside rearview mirror (B).

    Tightening torque: 6.9~10.8 N·m

  4. Installation is the reverse of removal.
Inside Rear View Mirror Assembly Replacement

Mirror Replacement

  1. Press down on the base of the inside rear view mirror (A) to remove the inside rear view mirror assembly (B).
  2. Installation is the reverse of removal.

ECM Mirror Replacement

  1. Remove the ECM mirror cover (A).
  2. Disconnect the ECM mirror connector (B).
  3. Loosen the ECM mirror mounting screw (A).
  4. Push the ECM mirror base upward to remove the ECM mirror assembly (B).
  5. Installation is the reverse of removal.
    • Make sure the connector is properly connected.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.