Kia Cadenza VG Owner's Manual Quiz
Emission Control System

On-Board Refueling Vapor Recovery (ORVR) Repair Procedures

In this manual: Emission Control System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
7steps
~42min
2/5difficulty
010203040502.92N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Turn the ignition switch OFF and disconnect the (-) battery cable.
  2. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank".)
  3. Disconnect the vapor hose (A).
  4. Remove the mounting bolts (B), then remove the ORVR valve (C) from the fuel tank.

Inspection

  1. Visually inspect the valve and gasket for deformation or damage.
  2. Check that air flows smoothly when blowing into the ORVR valve nipple, as shown below.
  3. Check that there is resistance when applying air to the ORVR valve nipple, as shown below.

Installation

  1. Install in the reverse order of removal.

    ORVR Mounting Bolt: 1.9 ~ 2.9 N·m

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.