Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
27steps
~162min
4/5difficulty
Done 0 of 27

Inspection

Front Door Lock Actuator Inspection
  1. Remove the front door trim panel. (Refer to Body - "Front Door")
  2. Remove the front door module.
  3. Disconnect the 6P connector from the actuator.
  4. Check actuator operation by connecting power and ground as specified in the table. To prevent actuator damage, apply battery voltage only momentarily.
  5. Remove the rear door trim panel. (Refer to Body - "Rear Door")
  6. Remove the rear door module.
  7. Disconnect the 6P connector from the actuator.
  8. Check actuator operation by connecting power and ground as specified in the table. To prevent actuator damage, apply battery voltage only momentarily.
  9. Remove the trunk lid trim panel. (Refer to Body - "Trunk Lid")
  10. Disconnect the 3P connector from the actuator.
  11. Check actuator operation by connecting power and ground as specified in the table. To prevent actuator damage, apply battery voltage only momentarily.
  12. Remove the front door panel. (Refer to Body - "Front Door")
  13. Remove the front door module.
  14. Disconnect the 6P connector from the actuator.
  15. Check the continuity between the terminals at each switch position when the key is inserted into the door, according to the table.
  16. Remove the rear door panel. (Refer to Body - "Rear Door")
  17. Remove the rear door module.
  18. Disconnect the 6P connector from the actuator.
  19. Check the continuity between the terminals at each switch position according to the table.
  20. Remove the trunk lid trim. (Refer to Body - "Trunk Lid")
  21. Disconnect the 3P connector from the actuator.
  22. Check the continuity between the terminals at each switch position according to the table.
  23. Disconnect the connector from the hood switch (A).
  24. Check the continuity between the terminals and ground according to the table.
  25. Remove the siren (A) by removing 1 bolt, and disconnect the 2-pin connector from the siren.
  26. Check the siren by connecting battery power to terminal 1 and grounding terminal 2.
  27. The burglar horn should sound. If the burglar horn does not sound, replace it.
Rear Door Lock Actuator Inspection Trunk Lid Release Actuator Inspection Front Door Lock Switch Inspection Rear Door Lock Switch Inspection Trunk Lid Open Switch Inspection Door Switch Inspection Remove the door switch and check the continuity between the terminals. Hood Switch Inspection Intrusion Horn Inspection

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.