Transmitter Repair Procedures

Inspection

1. 1
   Make sure the red indicator blinks when the door lock or unlock button on the transmitter is pressed.
2. 2
   Remove the battery (A) and check the voltage if the red indicator does not blink.

   Standard voltage: 3 V

   

3. 3
   Insert the battery (A) into the tester (09954-2P100).

   

4. 4
   Press the check button. If "0.00" is displayed on the screen, the battery voltage is 2 V or less.
5. 5
   If "L" is displayed on the screen, the battery is discharged and must be replaced.
6. 6
   To prevent electrical discharge, turn off the power to the tester.
7. 7
   Replace the transmitter battery with a new one if the voltage is low, then try to lock and unlock the doors using the transmitter by pressing the lock or unlock button five or six times.
8. 8
   If the doors lock and unlock, the transmitter is normal. If the doors do not lock or unlock, register the transmitter code, then try to lock and unlock the doors.
9. 9
   If the doors lock and unlock, the transmitter is normal. If the doors do not lock or unlock, replace the transmitter.

Transmitter Code Registration (Using GDS)

1. 1
   Connect the GDS DLC cable to the data link connector (16-pin) on the lower driver's side instrument panel, then turn on the GDS.

   

2. 2
   Select the vehicle model, then perform "CODE SAVER".

   

3. 3
   After selecting the "CODE SAVER" menu, press the "ENTER" button. The screen shown below will appear.

   

4. 4
   After removing the ignition key from the key cylinder, press the "ENTER" key to move to the next code saving mode. Perform steps 1 through 4. Code saving is then complete.