Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

Check this by performing the procedure below to confirm that the ECM operates normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor to disable it.
  3. Shine a flashlight on the rear sensor.
  4. The ECM should dim as soon as the rear sensor detects light.
  5. When the reverse gear is engaged, the ECM should not dim.
  6. When both the front and rear sensors are illuminated, the ECM should not dim.

Removal

  1. Remove the mirror wiring cover (A) and disconnect the mirror connector (B).
  2. Remove the mounting screw (A).
  3. Remove the mirror (A) by pulling up in the direction of the arrow.

Installation

  1. Install the mirror, making sure the mounting bracket is not damaged.
  2. Install the mirror wiring cover after reconnecting the connector and tightening the screw.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.