Body Electrical System
Blind Spot Detection Indicator Repair procedures
In this manual: Body Electrical System
8steps
~48min
2/5difficulty
Done 0 of 8
Removal
Blind Spot Detection Warning Indicator
Disconnect the negative (-) battery terminal.
Remove the mirror (A) from the mirror holder.

Disconnect the mirror heated connector (B) and BSD indicator connector (A).

Remove the BSD indicator (A).

Installation
Blind Spot Detection Warning Indicator
Install the BSD indicator.
Connect the mirror heated connector and BSD indicator connector.
Install the mirror.
Connect the negative (-) battery terminal.
Inspection
Verify that the mirror operates properly as shown in the below table.


Was this page helpful?